D-Link DXS-3600 Series Reference Manual page 806

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
AREA-ID
PREFIX/PREFIX-LENGTH
advertise
not-advertise
Default
By default, this option is disabled.
If advertise or not-advertise is not specified, the default option is advertise.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can be applied to the same area multiple times. Use this command on the ABR to
summarize the intra-area routes. This command can be used to specify the summarized route for area 0
or for the non-zero area. Multiple area range commands can be configured. Thus, OSPF can summarize
addresses for multiple sets of address ranges.
Example
This example shows how to configure one summary route to be advertised by the ABR to other areas for
all subnets on network 192.168.0.0.
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# area 1 range 192.168.0.0 255.255.0.0
Switch(config-router)#
71-4 area stub
This command is used to specify an area as a stub area. Use the no command to remove the stub
related settings associated with the area.
area AREA-ID stub [no-summary]
no area AREA-ID stub [no-summary]
Parameters
AREA-ID
no-summary
Default
By default, an area is a normal area.
Command Mode
Router Configuration Mode.
Specifies the area from which the routes will be summarized.
Specifies the prefix and length of the prefix of the summary route.
(Optional) Specifies to advertise a Type-3 summary LSA for the
specified range of addresses.
(Optional) Specifies to suppress the advertising of Type-3 summary
LSAs. Component routes are still hidden behind it.
Specifies the ID of the area to be assigned as a stub area.
(Optional) Specifies that the stub area is a total stub area.
806