D-Link DXS-3600 Series Reference Manual page 641

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# port-channel load-balance src-ip
Switch(config)#
57-6 show channel-group
This command is used to display the channel group information.
show channel-group [channel [CHANNEL-NO] {detail | neighbor} | load-balance | sys-id]
Parameters
CHANNEL-NO
channel
detail
neighbor
load-balance
sys-id
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If a port-channel number is not specified, all port-channels will be displayed. If the channel, load-balance
and sys-id keywords are not specified with the show channel-group command, only summary channel-
group information will be displayed.
Example
This example shows how to display the detailed information of all port-channels.
Switch# show channel-group channel detail
Flag:
S - Port is requesting Slow LACPDUs
A - Port is in active mode
LACP state:
bndl: Port is attached to an aggregator and bundled with other ports.
hot-sby:
indep:
down:
Channel Group 1
Member Ports: 2, Maxports = 12, Protocol: LACP
(Optional) Specifies the channel group ID.
(Optional) Specifies to display information for the specified port-
channels.
(Optional) Specifies to display detailed channel group information.
(Optional) Specifies to display neighbor information.
(Optional) Specifies to display the load balance information.
(Optional) Specifies to display the system identifier that is being used
by LACP.
Port is in a hot-standby state.
Port is in an independent state(not bundled but able to switch data
traffic)
Port is down
LACP
F - Port is requesting fast LACPDU
P - Port is in passive mode
Port Port
641