D-Link DXS-3600 Series Reference Manual page 196

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
HOLDTIME: 180 seconds.
Command Mode
Router Configuration Mode.
Address Family Configuration (VRF) Mode.
Command Default Level
Level: 12.
Usage Guideline
The timers configured for a specific neighbor or peer group override the timers configured for all BGP
neighbors using the timers bgp command. If the minimum acceptable hold time is configured, the BGP
session will only be established when the remote peer is equal to or greater than the minimum hold time.
Example
This example shows how to configure the KEEP-ALIVE timer to 120 seconds and HOLD-TIME timer to
360 seconds for the neighbor 172.16.10.10.
Switch# configure terminal
Switch(config)# router bgp 65100
Switch(config-router)# neighbor 172.16.10.10 timers 120 360
10-61 neighbor unsuppress-map
This command is used to selectively advertise routes that are previously suppressed by the aggregate-
address command. Use the no form of this command to remove the unsuppressed route map.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} unsuppress-map MAP-NAME
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} unsuppress-map
Parameters
IP-ADDRESS
PEER-GROUP-NAME
MAP-NAME
Default
No routes are unsuppressed.
Command Mode
Router Configuration Mode.
Address Family Configuration (IPv4 unicast, VPNv4 and VRF) Mode.
Command Default Level
Level: 12.
Usage Guideline
When a route map is applied by the neighbor unsuppress-map command, the suppressed route that
matches the permit rule will be unsuppressed. It provides manipulation of routes per neighbor.
Example
Specifies the IP address of the neighbor router.
Specifies the neighbor peer group.
Specifies the route map to selectively unsuppress the routes
suppressed by the aggregate-address command.
196