D-Link DXS-3600 Series Reference Manual page 45

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# vlan access-map vlan-map 20
Switch(config-access-map)# action redirect eth1/0/5
Switch(config-access-map)# end
Switch# show vlan access-map
VLAN access-map vlan-map 20
match mac address:
action: redirect eth1/0/5
Switch#
4-4 clear acl-hardware-counter
This command is used to clear the ACL hardware counter.
clear acl-hardware-counter {access-group [ACCESS-LIST-NAME | ACCESS-LIST-NUMBER] |
vlan-filter [ACCESS-MAP-NAME]}
Parameters
access-group ACCESS-LIST-
NAME
access-group ACCESS-LIST-
NUMBER
vlan-filter ACCESS-MAP-
NAME
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
If no access-list name or number is specified with the parameter access-group, all access-group
hardware counters will be cleared. If no access-map name is specified with the parameter vlan-filter, all
VLAN filter hardware counters will be cleared.
Example
This example shows how to clear the ACL hardware counter.
Switch(config)# clear acl-hardware-counter access-group abc
Switch#
4-5 expert access-group
This command is used to apply a specific expert ACL to an interface. Use the no command to cancel the
application.
ext_mac(ID: 6856)
Specifies the name of the access list to be cleared.
Specifies the number of the access list to be configured.
Specifies the name of the access map to be cleared.
45