D-Link DXS-3600 Series Reference Manual page 469

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Error frame seconds event
Notify state
Threshold
Window
Switch#
36-12 show ethernet oam status
This command is used to display the status of the Ethernet OAM function.
show ethernet oam status [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
The command used to display primary controls and status information for Ethernet OAM on specified
ports.
Example
This example shows how to display the Ethernet OAM status of interface eth1/0/1.
Switch# show ethernet oam status interface eth1/0/1
eth1/0/1
Local client
Admin State
Mode
Max OAMPDU size
Remote loopback
Unidirectional
Link monitoring
Variable request
PDU revision
Operation status
: Enabled
: 1 error frame
: 600 deciseconds
Specifies the interface ID to display. The allowed interfaces only
include physical ports.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
: Enabled
: Active
: 1518 bytes
: Support
: Not support
: Support
: Not support
: 1
: Operational
469