D-Link DXS-3600 Series Reference Manual page 467

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 12.
Usage Guideline
The command is used to request the remote peer to enter or exit the Ethernet OAM remote loopback
mode. Use the ethernet oam remote-loopback start command to request the remote peer to enter the
Ethernet OAM remote loopback mode. Use the ethernet oam remote-loopback stop command to
request the remote peer to exit the Ethernet OAM remote loopback mode.
If the remote peer is configured to ignore the remote loopback request, then the remote peer will not enter
or exit the remote loopback mode upon receiving the request. To start the remote peer to enter the
remote loopback mode, administrators must ensure that the local client is in the active mode and the
OAM connection is established. If the local client is already in the remote loopback mode, then this
command cannot be applied.
Example
This example shows how to start the Ethernet OAM remote loopback on interface eth1/0/1.
Switch# ethernet oam remote-loopback start interface eth1/0/1
Switch#
36-10 ethernet oam received-remote-loopback
This command is used to configure the behavior of the received remote loopback requirement from the
peer on the specified port. To return to the default settings, use the no form of this command.
ethernet oam received-remote-loopback {process | ignore}
Parameters
process
ignore
Default
The Ethernet OAM ignores remote loopback requirement by default.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to configure the client to process or to ignore the received Ethernet OAM remote
loopback command. In the remote loopback mode, all user traffic will not be processed. Ignoring the
received remote loopback command will prevent the port from entering the remote loopback mode.
Example
This example shows how to enable processing the Ethernet OAM remote loopback command on
interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# ethernet oam received-remote-loopback process
Switch(config-if)#
Specifies to react to remote loopback requirements from a peer.
Specifies not to react to remote loopback requirements from a peer.
467