D-Link DXS-3600 Series Reference Manual page 208

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the configured AS-path access-lists. If the access list name is not specified,
all as-path access-lists are displayed.
Example
This example shows how to display all of the configured AS path access list.
Switch#show ip as-path access-list
AS path access list A1
permit .*
AS path access list A2
permit .*
Total Entries: 2
Switch#
10-75 show ip bgp
This command is used to display entries in the Border Gateway Protocol (BGP) routing table.
show ip bgp [ipv4 unicast | vpnv4 {all | rd RD-VALUE | vrf VRF-NAME}] [IP-ADDRESS [/PREFIX-
LENGTH [longer-prefixes]] | route-map NAME]
Parameters
ipv4
vpnv4
unicast
all
rd RD-VALUE
vrf VRF_NAME
IP-ADDRESS
PREFIX-LENGTH
longer-prefixes
NAME
Default
(Optional) Specifies to display the IPv4 address family routing entries.
(Optional) Specifies to display the VPNv4 address family routing
entries
Specifies to display unicast address family routing entries.
Specifies to display all the VPNv4 routing entries.
Specifies to display the VPNv4 routing entries that match the specified
RD.
Specifies to display the VPNv4 routing entries associated with the
VRF.
(Optional) Specifies the IP network to display only a particular network
in the BGP routing table.
(Optional) Specifies the length of prefix of the specified network.
(Optional) Specifies to display the specified route and all more specific
routes.
(Optional) Specifies to filter the output based on the specified route
map.
208