D-Link DXS-3600 Series Reference Manual page 654

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
SECONDS
Default
By default, this value is 2 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A re-enabled LLDP physical interface will wait for the re-initialization delay after the last disable command
before reinitializing.
Example
This example shows how to configure the re-initialization delay interval to 5 seconds.
Switch# configure terminal
Switch(config)# lldp reinit 5
Switch(config)#
58-12 lldp run
This command is used to enable the Link Layer Discovery Protocol (LLDP) globally. Use the no form of
this command to return to the default settings.
lldp run
no lldp run
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to globally enable LLDP and then the switch can start to transmit LLDP packets and
receive and process the LLDP packets. However, the transmission and receiving of LLDP can be
controlled respectively by the lldp transmit command and the lldp receive command in the interface
configuration mode. LLDP takes effect on a physical interface only when it is enabled both globally and
on the physical interface.
Specifies the delay value for LLDP initialization on an interface. This
value must be between 1 and 10 seconds.
654