D-Link DXS-3600 Series Reference Manual page 724

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
65-3 mvlan vlan
This command is used to create a multicast VLAN. Use the no form of this command to remove a
multicast VLAN.
mvlan vlan VLAN-ID
no mvlan vlan VLAN-ID
Parameters
vlan VLAN-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A VLAN that has been created as an ordinary 802.1Q VLAN cannot be specified as a multicast VLAN and
vice versa. A VLAN cannot be IGMP snooping enabled and specified as a multicast VLAN at the same
time.
Example
This example shows how to create the multicast VLAN 100.
Switch# configure terminal
Switch(config)# mvlan ipv4 enable
Switch(config)# mvlan vlan 100
Switch(config-mvlan)#
65-4 member
This command is used to configure interfaces as source ports or as receiver ports of a multicast VLAN.
Use the no form of this command to remove receiver ports or source ports.
member {receiver | source} {tagged | untagged} INTERFACE-ID [, | -]
no member {receiver | source} INTERFACE-ID [, | -]
Parameters
receiver
source
Tagged
Specifies the multicast VLAN to create. The range is 1 to 4094.
Specifies to configure the port as a subscriber port that can only
receive multicast data in the multicast VLAN.
Specifies to configure the port as an uplink port that can send multicast
data in the multicast VLAN.
Specifies that if a port is a tagged member, the packets sent from the
port are tagged with the Multicast VLAN ID.
724