D-Link DXS-3600 Series Reference Manual page 270

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# cfm domain op-domain level 2
Switch(config-cfm-md)# cfm ma name op1 vlan 2
Switch(config-cfm-ma)#
14-12 cfm mep
This command is used to define a maintenance association end-point and enter the CFM MEP
Configuration Mode. To delete an MEP, use the no command.
cfm mep mepid MEP-ID ma name MA-NAME domain DOMAIN-NAME [direction {up | down}]
no cfm mep mepid MEP-ID ma name MA-NAME domain DOMAIN-NAME
Parameters
mepid MEP-ID
name MA-NAME
domain DOMAIN-NAME
direction
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to define a maintenance association end point. Each MEP configured in the same
MA must have a unique MEP ID. The MEP on different MA can have the same MEPID. Before creating a
MEP, its MEP ID should be configured in the MA's MEP ID list.
Example
This example shows how to configure an MEP by MPs on the specified physical interface. Assign the
direction of the MEP up.
Switch# configure terminal
Switch(config)# cfm domain op-domain level 2
Switch(config-cfm-md)# cfm ma name op1 vlan 2
Switch(config-cfm-ma)# mepid-list add 1-2
Switch(config-cfm-ma)# exit
Switch(config-cfm-md)# exit
Switch(config)# interface eth1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain direction up
Specifies the MEP ID. The range is from 1 to 8191.
Specifies the MA name as the identifier.
Specifies the MD name as the identifier. It is a string type of maximum
length 22.
(Optional) Specifies the direction of the MEP.
Up: Inward facing (up) MEP.
Down: Outward facing MEP
When creating an MEP, the direction of the MEP should be specified.
If not specified, it means to enter the CFM MEP Configuration Mode
for an existed MEP.
270