D-Link DXS-3600 Series Reference Manual page 726

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
VLAN-NAME
Default
The default multicast VLAN name is MVLANxxxx, where xxxx represents four numeric digits (including
the leading zero) that are equal to the VLAN ID.
Command Mode
Multicast VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the name of a multicast VLAN.
Example
This example shows how to configure the multicast VLAN name of multicast VLAN 100 to "ip-tv".
Switch# configure terminal
Switch(config)# mvlan
Switch(config)# mvlan 100
Switch(config-mvlan)# name ip-tv
Switch(config-mvlan)#
65-6 replace-priority
This command is used to replace the priority of data traffic forwarded in the multicast VLAN. Use the no
form of this command to cancel the priority replacement.
replace-priority {ipv4 PRIORITY | ipv6 PRIORITY}
no replace-priority {ipv4 | ipv6}
Parameters
ipv4 PRIORITY
ipv6 PRIORITY
Default
None.
Command Mode
Multicast VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If the replacing priority option is configured, the multicast data packets forwarded on the multicast VLAN
will be tagged with the replacing priority option. Otherwise the priority is the value of the original packet.
Specifies the VLAN name, with a maximum of 32 characters.
Specifies the remap priority for IPv4 multicast packets forwarded on
the multicast VLAN.
Specifies the remap priority for IPv6 multicast packets forwarded on
the multicast VLAN.
726