Basic Ipv4 Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
8.

Basic IPv4 Commands

8-1 arp
This command is used to add a static entry in the Address Resolution Protocol (ARP) cache. Use the no
command to remove a static entry in the ARP cache.
arp [vrf VRF-NAME] IP-ADDRESS HARDWARE-ADDRESS
no arp [vrf VRF-NAME] IP-ADDRESS HARDWARE-ADDRESS
Parameters
VRF-NAME
IP-ADDRESS
HARDWARE-ADDRESS
Default
No static entries are installed in the ARP cache.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The ARP table keeps the network layer IP address to local data-link MAC address association. The
association is kept so that the addresses will not have to be repeatedly resolved. Use this command to
add static ARP entries.
Example
This example shows how to add a static ARP entry for a typical Ethernet host.
Switch# configure terminal
Switch(config)# arp 10.31.7.19 0800.0900.1834
8-2 arp timeout
This command is used to set the ARP aging time for the ARP table. Use the no command to revert to
default setting.
arp timeout MINUTES
no arp timeout
Parameters
MINUTES
(Optional) Specifies the name of the VRF instance.
Specifies the network layer IP address.
Specifies the local data-link Media Access (MAC) address (a 48-bit
address).
Specifies the dynamic entry that will be aged-out if it has no traffic
119