D-Link DXS-3600 Series Reference Manual page 545

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
•
Last member query count – The number of group-specific queries sent before the router
assumes there are no local members of a group. The default number is the value of the
robustness variable.
Users can increase this value if a subnet is expected to be loose.
Example
This example shows how to configure the robustness variable to be 3 on interface VLAN 1000.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ip igmp snooping robustness-variable 3
Switch(config-vlan)#
44-17 ip igmp snooping static-group
This command is used to configure an IGMP snooping static group. Use the no form of this command is
used to delete a static group.
ip igmp snooping static-group GROUP-ADDRESS interface INTERFACE-ID [,|-]
no ip igmp snooping static-group GROUP-ADDRESS [interface INTERFACE-ID [,|-]]
Parameters
GROUP-ADDRESS
INTERFACE-ID
,
-
Default
By default, no static-group is configured.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. This command applies to IGMP
snooping on a VLAN interface to statically add group membership entries and/or source records.
The ip igmp snooping static-group command allows the user to create an IGMP snooping static group
in case that the attached host does not support the IGMP protocol.
Example
This example shows how to statically add a group and source records for IGMP snooping.
Switch# configure terminal
Switch(config)# vlan 1
Specifies a IP multicast group address.
(Optional) Specifies an interface or an interface list. The interface can
be a physical interface or a port-channel.
(Optional) Specifies a series of interfaces, or a separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
545