D-Link DXS-3600 Series Reference Manual page 420

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to display neighbor information.
Switch# show ip dvmrp neighbor
Interface
---------------
vlan1
Total Entries: 1
Switch#
Display Parameters
Interface
Neighbor Address
Generation ID
ExpTime
28-7 show ip dvmrp route
This command is used to display DVMRP route information.
show ip dvmrp route [NETWORK-ADDRESS]
Parameters
NETWORK-ADDRESS
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Neighbor Address Generation ID
---------------- -------------
10.10.10.11 35ef6d
The interface referred to the routing interface and it is mapped to a
VLAN interface.
Once a system has received a probe from a neighbor, that contains
the system's address in the neighbor list, the system has established a
two-way neighbor adjacency with this router.
If a DVMRP router was restarted, it will not be aware of any previous
prunes that it had sent or received. In order for the neighbor to detect
that the router has restarted, a non-decreasing number is placed in the
periodic probe message called the generation ID. When a change in
the generation ID is detected, any prune information received from the
router is no longer valid and should be flushed.
The neighbor timeout interval should be set at 35 seconds. This allows
fairly early detection of a lost neighbor yet provides tolerance for busy
multicast routers. These values must be coordinated between all
DVMRP routers on a physical network segment. The expire-time
value, shown here, is how much time remained before reaching the
timeout interval.
(Optional) Specifies the source network address and mask length. If
the network address not specified, all DVMRP routes will be displayed.
420
ExpTime
-----------
0DT00H00M29S