D-Link DXS-3600 Series Reference Manual page 843

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
None.
Default
By default the OSPF interface state debug switch is turned off.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the OSPF interface state debug switch. When the OSPF interface
state changes or some events happen to change the interface state, debug information will print. When
DR selection happens, debug information will also print if the OSPF debug function is turned on.
Example
This example shows how to turn on the OSPF interface state debug switch.
Switch# debug ip ospf interface
Switch#
intf 10.1.1.1 up tic 10
intf 100.1.1.1 down tic 20
OSPF: Select DR: 2.2.2.2
OSPF: Select BDR: 1.1.1.1
71-42 debug ip ospf lsa-originating
This command is used to turn on the OSPF interface state debug switch. Use the no form of the
command to turn off the OSPF interface state debug switch.
debug ip ospf lsa-originating
no debug ip ospf lsa-originating
Parameters
None.
Default
By default the OSPF interface state debug switch is turned off.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the OSPF LSA originating debug switch. When the LSA is
originated, debug information will print if the OSPF debug function is turned on.
Example
This example shows how to turn on the OSPF LSA originating debug switch.
843