D-Link DXS-3600 Series Reference Manual page 374

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
CLIENT-HARDWARE-
ADDRESS
Default
None.
Command Mode
Configure DHCP Server Screen Mode.
Command Default Level
Level: 12.
Usage Guideline
If a binding entry is defined with the client's MAC address, then the server message with the specified
server IP address and client address in the payload will be permitted. These binding entries restrict that
only specific servers are allowed to offer addresses to service specific clients.
If a binding entry is defined without the client's MAC address, then the server message with the specified
server IP address in the payload will be permitted. These binding entries restrict that only specific servers
are allowed to offer DHCP server services.
Example
This example shows how to configure a DHCP server screen profile named "campus-profile" which
contains a list of MAC addresses of clients.
Switch# configure terminal
Switch(config)# dhcp-server-screen profile campus-profile
switch(config-dhcp-server-screen)# based-on hardware-address 00-08-01-02-03-04
switch(config-dhcp-server-screen)# based-on hardware-address 00-08-01-03-00-01
switch(config-dhcp-server-screen)#
22-18 clear ip dhcp snooping server-screen log
This command is used to clear the server screen log buffer.
clear ip dhcp snooping server-screen log
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to clear the server screen log buffer. The DHCP server screen log buffer keeps tracks
the information of packet that does not pass the screening. The first packet that violates the check will be
(Optional) Specifies the MAC address of the client.
374