Show Monitor Session - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the remote-span command in the VLAN configuration mode to specify a VLAN as an RSPAN VLAN.
When a VLAN is specified as an RSPAN VLAN, the MAC address learning option on the RSPAN VLAN is
disabled. Use this command on the middle switch and the destination switch involved in the RSPAN
session.
For the middle switch involved in a RSPAN session, the port that the monitored packet arrives and the
port that the monitored packets will be transmitted need to be configured as tagged member ports of the
RSPAN VLAN.
Example
This example shows how to assign VLAN 100 as the RSPAN VLAN in the middle switch of the RSPAN
session. Interface ethernet3/0/1 is where the monitored packets arrive and ethernet3/0/5 is where the
monitored packet is transmitted.
Switch# configure terminal
Switch(config)# interface ethernet3/0/1
Switch(config-if)# switchport mode trunk
Switch(config-if)# switchport trunk allowed vlan 100
Switch(config-if)# exit
Switch(config)# interface ethernet3/0/5
Switch(config-if)# switchport mode trunk
Switch(config-if)# switchport trunk allowed vlan 100
Switch(config-if)# exit
Switch(config)# vlan 100
Switch(config-vlan)# remote-span
Switch(config-vlan)#

61-7 show monitor session

This command is used to display all or a specific port mirroring session.
show monitor session [SESSION-NUMBER | remote | local]
Parameters
SESSION-NUMBER
local
remote
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
(Optional) Specifies the session number which you want to display.
(Optional) Specifies to display the local session.
(Optional) Specifies to display the remote RSPAN session.
688