D-Link DXS-3600 Series Reference Manual page 632

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no l2protocol-tunnel cos
Parameters
COS-VALUE
Default
By default, this value is 5.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When a Layer 2 protocol packet arrives at a port that is enabled for the Layer 2 protocol tunnel, the switch
will encapsulate the packet with a service VLAN tag and rewrites the CoS with the value specified by this
command.
Example
This example shows how to specify a CoS value for tunneling of the protocol packets.
Switch# configure terminal
Switch(config)# l2protocol-tunnel cos 7
Switch(config)#
56-4 l2protocol-tunnel drop-threshold
This command is used to specify the threshold in tunneling of the specified Layer 2 protocol packets
received by a port before it is dropped. Use the no form of the command to reset to the default setting.
l2protocol-tunnel drop-threshold [gvrp | stp | protocol-mac {01-00-0c-cc-cc-cc | 01-00-0c-cc-cc-
cd}] PPS
no l2protocol-tunnel drop-threshold [gvrp | stp | protocol-mac {01-00-0c-cc-cc-cc | 01-00-0c-cc-
cc-cd}]
Parameters
gvrp
stp
01-00-0c-cc-cc-cc
01-00-0c-cc-cc-cd
PPS
Default
None.
Specifies the CoS value. The values are from 0 to 7. 7 is the highest
priority.
(Optional) Specifies GVRP packets.
(Optional) Specifies STP packets.
(Optional) Specifies the protocol packets with this destination DA.
(Optional) Specifies the protocol packets with this destination DA.
Specifies the threshold in number of packets per second This value
must be between 1 and 4096 packets per second.
632