D-Link DXS-3600 Series Reference Manual page 625

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-source-guard)#
54-4 permit link-local
This command is used to allow hardware permitted data traffic send by the link-local address. Use the no
form of this command to disable this function
permit link-local
no permit link-local
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Source-guard Policy Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to enable hardware to permit data traffic sent by the link-local address.
Example
This example shows how to allow all data traffic that is send by the link-local address.
Switch# configure terminal
Switch(config)# ipv6 source-guard policy policy1
Switch(config-source-guard)# permit link-local
Switch(config-source-guard)#
54-5 ipv6 source-guard attach-policy
This command is used to apply IPv6 source guard on an interface. Use the no form of the command to
remove this source guard from the interface.
ipv6 source-guard attach-policy [POLICY-NAME]
no ipv6 source-guard attach-policy
Parameters
POLICY-NAME
Default
None.
Command Mode
Specifies the name of the source guard policy.
625