D-Link DXS-3600 Series Reference Manual page 543

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
44-14 ip igmp snooping rate-limit
This command is used to configure the upper limit per second for ingress IGMP control packets. Use the
no form of this command to disable the rate limit.
ip igmp snooping rate-limit NUMBER
no ip igmp snooping rate-limit
Parameters
NUMBER
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for VLAN interface configuration, physical port or port-channel interface. The
command configures the rate of IGMP control packet that can be processed by IGMP snooping.
Example
This example shows how to limit 30 packets per second on interface VLAN 1000.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ip igmp snooping rate-limit 30
Switch(config-vlan)#
44-15 ip igmp snooping report-suppression
This command is used to enable the report suppression. Use the no form of this command to disable the
report suppression.
ip igmp snooping report-suppression
no ip igmp snooping report-suppression
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Specifies to configure the rate of the IGMP control packet that the
switch can process on a specific interface. The rate is specified in
packets per second.
543