D-Link DXS-3600 Series Reference Manual page 740

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch#
This example shows how to display MSTP summary information for interfaces eth3/0/3 to eth 3/0/4 of
MST02.
Switch# show spanning-tree mst instance 2 interface eth3/0/3-4
>>>>MST02 vlans mapped:
Bridge Address:00-12-d9-87-47-00 , Priority: 32770 (32768 sysid 2)
Designated Root Address:00-12-d9-87-47-00 , Priority: 32770
Designated Bridge Address:00-12-d9-87-47-00 , Priority: 32770
Interface
---------
eth3/0/3
eth3/0/4
Switch#
This example shows how to display MSTP instance mapping configuration.
Switch# show spanning-tree mst configuration
Name : [region1]
Revision : 2, Instances configured: 3
Instance
---------
0
1
2
Switch#
66-5 spanning-tree mst
This command is used to configure the path cost and port priority parameters for any MST instance
(including the CIST with instance ID 0). To return to the default settings, use the no form of this command.
spanning-tree mst INSTANCE-ID {cost COST | port-priority PRIORITY}
no spanning-tree mst INSTANCE-ID {cost | port-priority}
Parameters
INSTANCE-ID
cost COST
port-priority PRIORITY
2-3
Role State
---- -----
backup blocking
backup blocking
Vlans
-------------
21-4094
1-10
11-20
Specifies the MSTP instance identifier.
Specifies the path cost for an instance. This value must be between 1
and 200000000.
Specifies the port priority for an instance. This value must be between
0 and 240 in increments of 16.
Priority
Cost .Port#
------ --------- ------
200000 128.3 p2p
200000 128.4 p2p
740
Link
Type Edge
--------
non-edge
non-edge