D-Link DXS-3600 Series Reference Manual page 486

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no rpl
Parameters
port0
port1
owner
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the ring node as the RPL owner node or neighbor node or next neighbor
nod of the configured instance and the ring port that acts as the RPL port.
Example
This example shows how to enable the RPL owner and configure port 0 as the RPL port of ERP instance
1.
Switch# configure terminal
Switch(config)# ethernet ring g8032 major-ring
Switch(config-erp)# port0 interface eth3/0/1
Switch(config-erp)# port1 interface eth3/0/2
Switch(config-erp)# instance 1
Switch(config-erp-instance)# rpl port0 owner
Switch(config-erp-instance)#
37-15 show ethernet ring g8032
This command is used to display information of the ERP instance.
show ethernet ring g8032 {status | brief}
Parameters
status
brief
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Specifies port 0 as the RPL port.
Specifies port 1 as the RPL port.
Specifies the ring node as the RPL owner node for the configured
instance.
Specifies to display the status of ERP instances.
Specifies to display brief information of ERP instances.
486