D-Link DXS-3600 Series Reference Manual page 70

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A VLAN access map can contain multiple sub-maps. For each sub-map, one access list (IP access list,
IPv6 access list or MAC access list) can be specified and one action can be specified. After a VLAN
access map is created, the user can use the vlan filter command to apply the access map to VLAN(s).
A sequence number will be assigned automatically if the user does not assign it manually, and the
automatically assigned sequence number starts from 10, and increase 10 per new entry.
The packet that matches the sub-map (that is packet permitted by the associated access-list) will take the
action specified for the sub-map. No further check against the next sub-maps is done. If the packet does
not match a sub-map, then the next sub-map will be checked.
Using the no form of this command without specify sequence numbers, will delete all sub-map
information of the specified access-map.
Example
This example shows how to create a VLAN access map.
Switch# configure terminal
Switch(config)# vlan access-map vlan-map 20
Switch(config-access-map)#
4-26 vlan filter
This command is used to apply a VLAN access map in a VLAN. Use the no command to remove a VLAN
access map from the VLAN.
vlan filter MAP-NAME vlan-list VLAN-ID-LIST
no vlan filter MAP-NAME vlan-list VLAN-ID-LIST
Parameters
MAP-NAME
VLAN-ID-LIST
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the name of the VLAN access map.
Specifies the VLAN ID list.
70