D-Link DXS-3600 Series Reference Manual page 556

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
Ethernet
PORTLIST
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command enters the interface configuration mode for the specified range of interfaces. Commands
configured in the interface range mode, applies to interfaces in the range.
Example
This example shows how to enter the interface configuration mode for the range of ports 2/0/1 to 2/0/5:
and port 3/0/3.
Switch# configure terminal
Switch(config)# interface range Ethernet 2/0/1-5, 3/0/3
Switch(config-if-range)#
45-5 show counters
This command is used to display interface information.
show counters [interface INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the statistic counters for an interface.
Example
This example shows how to display the counters for interface eth1/0/1.
Switch#show counter interface eth1/0/1
Specifies that Ethernet ports will be used for this configuration.
Enter the list of ports that will be used for this configuration here.
Specifies that the interface can be a physical port or VLAN interfaces.
If no interface is specified, counters of all interfaces will be displayed.
556