D-Link DXS-3600 Series Reference Manual page 954

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
There are a number of sources that a route can be learned from. Each route is associated with a distance.
The route with the least distance will be installed in routing table.
The value of maximum paths determines the maximum number of parallel routes to the same destination
network learned from the configured protocol that can be installed in the routing table simultaneously .The
installed parallel routes must belong to the same source.
Example
This example shows how to configure the maximum paths of the OSPF protocol to 3.
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# maximum-paths 3
Switch(config-router)#
80-8 show ip prefix-list
This command is used to display the configured prefix lists.
show ip prefix-list [PREFIX-LIST-NAME]
Parameters
PREFIX-LIST-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the IPv4 prefix list setting.
Example
This example shows how to display all of the configured IPv4 prefix lists.
Switch# show ip prefix-list
ip prefix-list customer-prefix:
Description: This prefix list is used for East-Branch.
count: 2
Seq 5 permit 10.20.0.0/16
(Optional) Specifies to display the entries of prefix list in specified
prefix list.
954