D-Link DXS-3600 Series Reference Manual page 542

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. This command configures the period of
which the group member can respond to an IGMP query message before the IGMP Snooping deletes the
membership.
Example
This example shows how to configure the maximum response time to 20 seconds on an interface.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ip igmp snooping query-max-response-time 20
Switch(config-vlan)#
44-13 ip igmp snooping query-version
This command is used to configure the general query packet version sent by the IGMP snooping querier.
Use the no form of this command to revert to the default setting.
ip igmp snooping query-version {1 | 2 | 3}
no ip igmp snooping query-version
Parameters
NUMBER
Default
By default, this value is 3.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. The query version number setting will
affect the querier electing. When configured to version 1, IGMP snooping will always act as the querier,
and will not initiate new querier electing no matter what IGMP query packet is received. When configured
to version 2 or version 3, IGMP snooping will initiate a new querier electing if any IGMPv2 or IGMPv3
query packet is received. When receiving an IGMPv1 query packet, IGMP snooping won't initiate a new
querier electing.
Example
This example shows how to configure the query version to be 2 on VLAN 1000.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ip igmp snooping query-version 2
Switch(config-vlan)#
Specifies the version of the IGMP general query sent by the IGMP
snooping querier.
542