D-Link DXS-3600 Series Reference Manual page 225

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
show ip bgp [ipv4 unicast | vpnv4 {all | rd RD-VALUE | vrf VRF-NAME}] neighbors [IP-ADDRESS
[advertised-routes | received prefix-filter | received-routes | routes]]]
Parameters
ipv4
vpnv4
unicast
all
rd RD-VALUE
vrf VRF-NAME
IP-ADDRESS
advertised-routes
received prefix-filter
received-routes
routes
Default
None.
Command Mode
EXEC Mode or any configuration mode,
Command Default Level
Level: 1.
Usage Guideline
Use this command to display BGP and TCP connection information for neighbor sessions. You can
specify the IPv4 address of a neighbor to display information about the specific neighbor. If no option is
specified for the command, the BGP neighbor information for IPv4 unicast address family is displayed. To
display the received routes from a neighbor, the BGP soft reconfigure command setting must be enabled
first.
Example
This example shows how to display the general neighbor information using the show ip bgp neighbors
command.
Switch# show ip bgp neighbors
BGP neighbor: 10.1.1.3, remote AS 1, internal link
BGP version: 4, remote router ID: 40.217.0.1
BGP state = Established, up for 00:24:52
(Optional) Specifies the IPv4 address family. The type of address
family determines the routing table that is displayed.
(Optional) Specifies the VPNv4 address family. The type of address
family determines the routing table that is displayed.
Specifies to display the unicast routing information.
(Optional) Specifies to display all the VPNv4 neighbors.
(Optional) Specifies to display the VPNv4 neighbors that match the
specified RD.
(Optional) Specifies to display the VPNv4 neighbors that match the
specified VRF.
(Optional) Specifies the IP address of a neighbor to be displayed. If not
specified, all neighbors are displayed.
(Optional) Specifies to display the routes advertised to a BGP
neighbor.
(Optional) Specifies to display the prefix-list received from the specified
neighbor.
(Optional) Specifies to display the routes received from a BGP
neighbor.
(Optional) Specifies to display the routes that are received and
accepted from a neighbor. The accepted routes are a subset of the
received routes.
225