D-Link DXS-3600 Series Reference Manual page 466

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
None.
Default
The Ethernet OAM critical event will be notified by default.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command used to configure the capability of the critical event. If the capability for a critical event is
disabled, the port will never send out OAM PDUs with critical event bit set when an unspecified critical
event has occurred.
Example
This example shows how to enable notifying critical events on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# ethernet oam remote-failure critical-event
Switch(config-if)#
36-9 ethernet oam remote-loopback
This command is used to set the action of the remote loopback on the specified port.
ethernet oam remote-loopback {start | stop} interface INTERFACE-ID [, | -]
Parameters
start
stop
interface INTERFACE-ID
,
-
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Specifies to request the peer to change to the remote loopback mode.
Specifies to request the peer to change to the normal operation mode.
Specifies the ID of an interface to do the remote loopback action. The
allowed interfaces only include physical ports.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
466