D-Link DXS-3600 Series Reference Manual page 397

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ipv6 dhcp pool POOL-NAME
no ipv6 dhcp pool POOL-NAME
Parameters
POOL-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter the IPv6 DHCP pool configuration mode and configure the IPv6 DHCP pool.
Use the ipv6 dhcp server command to enable the DHCP IPv6 server service on an interface and specify
the IPv6 DHCP pool used to service the DHCP request received on the interface.
Example
This example shows how to configure the address pool named "pool1".
Switch# configure terminal
Switch(config)# ipv6 dhcp pool pool1
Switch(config-dhcp)#
26-8 ipv6 dhcp server
This command is used to enable the DHCP IPv6 server service on an interface. Use the no form of this
command to disable the DHCP Ipv6 server service on an interface.
ipv6 dhcp server POOL-NAME [rapid-commit]
no ipv6 dhcp server
Parameters
POOL-NAME
rapid-commit
Default
None.
Command Mode
Interface Configuration Mode.
Specifies the name for the address pool. The maximum length is 32
characters.
Specifies the name of the IPv6 DHCP pool used to serve the request
received on the interface.
(Optional) Specifies to allow the proceeding of two-message
exchange. By default, two-message exchange is not allowed.
397