D-Link DXS-3600 Series Reference Manual page 174

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# router bgp 65100
Switch(config-router)# address-family ipv4 unicast
Switch(config-router-af)# neighbor 10.4.4.4 activate
10-35 neighbor advertisement-interval
This command is used to configure the minimum interval between two BGP routing UPDATE messages.
Use the no command to revert to the default setting.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} advertisement-interval SECONDS
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} advertisement-interval
Parameters
IP-ADDRESS
PEER-GROUP-NAME
SECONDS
Default
30 seconds for external peers.
5 seconds for internal peers.
Command Mode
Router Configuration Mode.
Address Family Configuration Mode (VRF).
Command Default Level
Level: 12.
Usage Guideline
If a BGP peer group is specified for the command, all the members of the peer group will inherit the
setting configured with this command.
Example
This example shows how to set the minimum time between sending BGP routing updates to 15 seconds.
Switch# configure terminal
Switch(config)# router bgp 65100
Switch(config-router=)# neighbor 10.4.4.4 advertisement-interval 15
10-36 neighbor allowas-in
This command is used to enable routers to allow their own AS appearing in the received BGP update
packets. To disable a duplicate AS number, use the no form of this command.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} allowas-in [NUMBER]
Specifies the IP address of the neighbor peer.
Specifies the name of the BGP peer group.
Specifies the minimum interval, in seconds, between the sending of
update messages. This value must be between 0 and 600.
174