D-Link DXS-3600 Series Reference Manual page 863

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default the cost is not configured.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Set the metric manually using the ipv6 ospf cost command. Using the bandwidth command changes
the link cost as long as the ipv6 ospf cost command is not used. The link-state metric is advertised as
the link cost in the router link advertisement.
Example
This example shows how to set the interface cost value to 65.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 ospf cost 65
Switch(config-if)#
72-11 ipv6 ospf dead-interval
This command is used to set the time period for which hello packets must not be seen before neighbors
declare the router down. To return to the default time, use the no form of this command.
ipv6 ospf dead-interval SECONDS
no ipv6 ospf dead-interval
Parameters
SECONDS
Default
The default interval is 40 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The interval is advertised in router hello packets. This value must be the same for all routers and access
servers on a specific network.
Example
metric. It can be a value in the range from 1 to 65535.
Specifies the interval in seconds, during which no packets are received
and after which a neighbor is regarded as off-line. The valid setting is
1-65535.
863