D-Link DXS-3600 Series Reference Manual page 736

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
MST Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Two Ethernet switches that have the same configuration but different revision numbers are considered to
be part of two different regions.
Example
This example shows how to configure the revision level of the MSTP configuration to 2.
Switch# configure terminal
Switch(config)# spanning-tree mst configuration
Switch(config-mst)# revision 2
Switch(config-mst)#
66-4 show spanning-tree mst
This command is used to display the information that used in the MSTP version.
show spanning-tree mst [configuration [digest]]
show spanning-tree mst [instance INSTANCE-ID [, | -]] [interface INTERFACE-ID [, | -]] [detail]
Parameters
configuration
digest
instance INSTANCE-ID [, | -]
interface INTERFACE-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Specifies to display the table for the mapping relationship between
VLANs and MSTP Instances.
Specifies to display the MD5 digest included in the current MST
configuration identifier (MSTCI).
Specifies to display the MSTP information for the designated instance
only. Define multiple instances by using ',' to specify a series of
instances or to separate a range of instances from a previous range.
Use '-' to specify a range of instances. No space before and after the
comma or hyphen.
Specifies to display the STP information for the specified interface.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
736