D-Link DXS-3600 Series Reference Manual page 134

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default, the IPv6 MTU value is 1500 bytes.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for Layer 3 capable interface configuration. Use this command to configure the
MTU to be advertised in RA messages. The IPv6 packet originated at the system will be transmitted
based on this value. The check is done in the egress direction. Oversized packets will be sent to the
supervisor blade for further processing.
Example
This example shows how to set the IPv6 MTU value as 6000 bytes at VLAN 4.
Switch# configure terminal
Switch(config)# interface vlan4
Switch(config-if) ipv6 mtu 6000
Switch(config-if)# exit
Switch(config)#
This example shows how to restore the default IPv6 MTU value.
Switch# configure terminal
Switch(config)# interface vlan4
Switch(config-if)# no ipv6 mtu
Switch(config-if)#
9-9 ipv6 nd managed-config-flag
This command is used to turn on the management configuration flag in the advertised RA message. Use
the no form of the command to turn off the flag.
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Parameters
None.
Default
By default, this feature is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
134