D-Link DXS-3600 Series Reference Manual page 240

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no debug ip bgp packet {receive | send}
Parameters
receive
send
Default
By default, the BGP packet debug switch is turned off.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on the BGP packet debug switch option. When BGP protocol packets are
received or transmitted, debug information will be print if the BGP debug function is turned on. Use the
command debug ip bgp to turn on the BGP debug function.
Example
This example shows how to turn on the BGP received packet debug switch option.
Switch# debug ip bgp packet receive
Switch#
BGP:Peer:<100.1.1.2>,RCV UPDATE,withdraw,NLRI:<88.1.1.0/24>,<88.1.2.0/24>,<88.1.
3.0/24>,<88.1.4.0/24>,<88.1.5.0/24>
100.1.1.2-Outgoing [DECODE] Update: Withdrawn Len(20)
100.1.1.2-Outgoing [RIB] Withdraw: Prefix 88.1.1.0
BGP:Peer:<10.1.1.3>,RCV KEEPAVLIVE
10.1.1.3-Outgoing [DECODE] KAlive: Received!
BGP:Peer:<100.1.1.2>,RCV UPDATE,attr:<Orign:i,As-path:(null),Next-hop:100.1.1.2>
,NLRI:<88.1.1.0/24>,<88.1.2.0/24>,<88.1.3.0/24>,<88.1.4.0/24>,<88.1.5.0/24>
100.1.1.2-Outgoing [DECODE] Update: NLRI Len(20)
100.1.1.2-Outgoing [RIB] Update: Received Prefix 88.1.1.0
10-103 debug ip bgp route-map
This command is used to turn on the BGP route map debug switch option. Use the no form of this
command to turn off the BGP route map debug switch option.
debug ip bgp route-map
no debug ip bgp route-map
Parameters
None.
Default
By default, the BGP route map debug switch option is turned off.
Specifies to turn on the BGP received packet debug switch option.
Specifies to turn on the BGP sent packet debug switch option.
240