Ipsec Tunnel Profile Configuration Mode; Ip Tunnel Destination Profile Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

host1(config)#ipsec transport profile secureL2tp virtual-router default ip address 0.0.0.0
host1(config-ipsec-transport-profile)#?
application Configure the application type that is protected by the l2tp
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
lifetime Configure the renegotiation time
local Configure local endpoint of the transport connection
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
pfs Configure perfect forward secrecy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
transform-set Configure the transform set used by ipsec transport profile

IPSec Tunnel Profile Configuration Mode

IP Tunnel Destination Profile Mode

Copyright © 2010, Juniper Networks, Inc.
In this mode, you can configure a profile of an IPSec tunnel.
From Global Configuration mode, type ipsec tunnel profile and the profileName, and
press Enter.
host1(config)#ipsec tunnel profile profile1
host1(config-ipsec-tunnel-profile)#?
default
do
domain-suffix
exit
extended-authentication
help
ike
ip
lifetime
local
log
macro
max-interfaces
no
peer
pfs
run
sleep
transform
tunnel
In this mode, you can specify parameters for GRE or DVMRP dynamic tunnels.
From Global Configuration mode, type gre destination profile or dvmrp destination
profile and the destination profile name, and press Enter.
host1(config)#gre destination profile global
host1(config-dest-profile)#?
Set a command to its default(s)
Run an exec mode command (alias command run)
Configure a domain suffix to be appended to users on
this profile
Exit from the current command mode
Configure extended authentication parameters
Describe the interactive help system
Configure IKE characteristics
Configure local IP characteristics
Configure the phase 2 life parameters
Configure local characteristics
Configure logging settings
Run a CLI macro
Configure the maximum allowed dynamic interface
instantiations
Negate a command or set its default(s)
Configure peer characteristics
Configure the phase 2 perfect forward secrecy
Run an exec mode command (alias command do)
Make the Command Interface pause for a specified
duration
Configure the phase 2 transforms allowed on this
IPSEC tunnel profile
Configure tunnel parameters
Chapter 2: Command-Line Interface
93