Configuring Basic Settings - Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual

Configuring Basic Settings

Copyright © 2010, Juniper Networks, Inc.
Your NSM3000 appliance comes preconfigured as a regional server or a central manager.
Most installation and configuration steps in this section are identical for both types of
server. All exceptions are noted.
After logging into the NSM3000 Web interface, NSM3000 provides you with the following
installation options:
Configuring Basic Settings on page 9
Configuring High Availability on page 11
Advanced Options on page 14
Installing NSM Software on page 17
To install the regional server or central manager software using the minimum
requirements:
Install your NSM3000 hardware as described in "Hardware Installation" on page 4.
1.
Boot and setup your NSM3000 appliance as described in "Initial Setup Configuration"
2.
on page 7.
Enter the https://<ip>/administration URL for your appliance in a Web browser. See
3.
"Web Interface Configuration" on page 8 for details.
Log into the Web interface. The
4.
Click the link
Install NSM Regional Server
5.
Regional Server window or click the
NSM Central Manager window (see Figure 4 on page 10), as the case may be.
NOTE: The "admin" user default username is admin and the password is
the one you created in Step 6 of "Boot NSM3000" on page 7.
System Info page opens.
(see Figure 3 on page 10) to go to the Install
Install NSM Central Manager
Configuring the NSM Software
link to view the Install
9