CHAPTER 10
Configuring SNMP
Configuring Basic System Identification for SNMP (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
This section contains the following:
To configure basic system identification information for SNMP:
1.
Click the Device Tree tab and then double-click the device for which you want to
2.
configure basic system identification information.
Click the Configuration tab. In the configuration tree, select Snmp.
3.
Add or modify basic system identification information as specified in Table 71 on
4.
page 118.
5.
OK-Saves the changes.
117