Throttle Cable - BRP can-am RENEGADE 500 2015 Operator's Manual

6. Gently open throttle plate and hold
fully open to reach all surfaces.
7. To remove residual dirt, spray
cleaner on throttle plate and on
bore.
8. Reinstall removed parts.

Throttle Cable

Throttle Cable Lubrication
The throttle cable must be lubricated
with CABLE LUBRICANT (P/N 293 600
041) or an equivalent.
WARNING
Always use a silicone-based lubri-
cant. Using another lubricant (like
a water-based lubricant) could
cause the throttle lever/cable to
become sticky and stiff.
Open the throttle lever housing.
V07I0FY
1. Remove these screws
Separate the housing.
Slide rubber protector back to expose
throttle cable adjuster.
1
______________
MAINTENANCE PROCEDURES
1
V07I0GY
1. Cable protector
2. Throttle cable adjuster
3. Lock nut
4. Throttle lever housing
Screw in the throttle cable adjuster.
Remove inner housing protector.
V07I0HY
1. Inner housing protector
Remove the cable from the throttle
lever housing.
NOTE: Slide cable in clip slot and re-
move the end of cable from clip.
2 3 4
1
107