– Unhook the retaining strap -5- on the rear part of the exhaust
system -1-.
– Unscrew screws -2-, -3-, -4- and remove the middle and rear
part of the exhaust system -1-.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
•
Tightening torques for vehicles with four-wheel drive and en‐
gine identification characters CJSB
•
Tightening torques for vehicles with front-wheel drive and en‐
gine identification characters CHHB
•
Rear left underfloor trim panel ⇒ body Work; Rep. gr. 66
– Align exhaust system free of stress
1.8
Aligning exhaust system free of stress
Work procedure
•
The exhaust system is aligned when cold.
– Loosen bolted connections -arrow- on clamping sleeve arrow.
– Push the rear silencer so far forward until the pre-tensioning
on the retaining strap on the exhaust pipe is -a- = 5 mm.
– Installing front clamping sleeve
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 334
⇒ page 333
⇒ page 339
.
⇒ page 328
.
1. Removing and installing parts of the exhaust system
Octavia III 2013 ➤ , Octavia III 2014 ➤
339