1)
Coat with hot bolt paste -G 052 112 A3-.
–
Align exhaust system free of stress
–
Install front exhaust pipe
Replacing front or rear silencer
Special tools, test equipment as well as aids required
t
Torque wrench 5 to 50 Nm (e.g. -V.A.G 1331-)
t
Body saw (e.g. -V.A.G 1523-)
A separation point is provided for repair purposes for replacing the front silencer or rear
silencer.
Separate exhaust pipe at right angles at
–
the separation point -arrow 2- with body
saw (e.g. -V.A.G 1523 -).
When installing clamping sleeve -4-
–
position on the side markings -arrows 1
and 3-.
Align exhaust system free of stress
–
→
Chapter.
–
Align rear silencer horizontally.
Tighten bolted connections of clamping
–
sleeve evenly to 40 Nm.
Installation position of clamping sleeve:
–
horizontal in vehicle, bolted connections
pointing forward.
Aligning exhaust system free of stress
Special tools and workshop equipment required
t
Torque wrench 5 to 50 Nm (e.g. -V.A.G 1331-)
Procedure
l
The exhaust system is aligned when cold.
→
Chapter.
→
Chapter.
124