23 -
q
24 -
25 -
q
replace
Removing and installing upper part of collecting intake manifold
Special tools and workshop equipment required
t
Torque wrench 5 to 50 Nm (e.g. -V.A.G 1331-)
t
Pliers for spring strap clips
t
2 hose clamps -MP 7-602 -
t
Cable strap
Removing
Note
All cable straps which are detached or cut open when removing, should be fitted on again in
the same place when installing.
On models fitted with a coded radio set, pay attention to the coding; determine if
–
necessary.
–
Disconnect the earth strap from the battery with the ignition off.
Remove caps for nuts and remove
–
engine cover -arrows-.
replace
Lifting eye
Cylinder head gasket
→ Chapter
Gasket
58