Shielding for drive shaft to cylinder block
1)
Coat with hot bolt paste -G 052 112 A3-.
–
Align exhaust system free of stress
Interrogating fault memory:
–
Rep. Gr. 01
Removing and installing exhaust manifold
Special tools and workshop equipment required
t
Torque wrench 5 to 50 Nm (e.g. -V.A.G 1331-)
Removing
–
Remove upper part of collecting intake manifold
–
Remove front exhaust pipe
Unscrew nuts -1- for shield -3-, take off
–
washers -2-.
Unscrew nuts -8- on both brackets -4-,
–
take off washers -7-.
Unscrew remaining nuts at exhaust
–
manifold -6-, take off washers.
Take off exhaust manifold and gasket -5-
–
for exhaust manifold.
Install
Note
t
Only use 4 mm thick washers.
t Replace gasket for exhaust manifold.
t Always replace self-locking nuts.
Components
Shield to exhaust manifold
Exhaust manifold to cylinder block
→
Chapter.
→ 1.6 ltr./74 kW Motor, Simos 2 Injection and ignition system;
→
Chapter.
123
→
Chapter.
35
Nm
25
25
→ Note