❑ 110 Nm
11 - Lock ring
❑ loosen and/or tighten using wrench - T30101 (3087)-
❑ 110 Nm
12 - Closing flange
❑ Removing and installing
13 - Sealing ring
❑ Replace after disassembly
❑ install when dry
14 - Fuel gauge sender 2 - G169-
❑ run an electrical test ⇒ Vehicle diagnostic tester
❑ Removing and installing
15 - Uptake with suction jet pump
❑ not available as spare part
❑ welded with the fuel tank
❑ Function of the suction jet pump
1.8
Removing and installing fuel delivery
unit and fuel gauge sender - G- on ve‐
hicles with front-wheel drive
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
♦ Key - T30101 (3087)-
Removing
•
The fuel tank must not be more than
Note
If necessary, extract fuel from the fuel tank
♦
Observe the safety instructions before starting fitting work
♦
⇒ page 2
.
Observe rules for cleanliness
♦
– Switch off ignition and all electrical loads, and pull out ignition
key.
– Removing rear seat bench ⇒ Body Work; Rep. gr. 72 .
– Unclip cover -1- for closing flange using the disassembly
wedge - 3409- from the uptake -arrows-.
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 241
⇒ page 241
⇒ page 249
3
/ 4 full.
⇒ page 221
⇒ page 9
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
233
1. Fuel tank