Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Install air guide with screw clamps
Note
Hose connections as well as charge air pipes and -hoses must
♦
be free of oil and grease before being installed.
Secure all hose connections with hose clamps which comply
♦
with the series design ETKA - ⇒ Electronic Catalogue of Orig‐
inal Parts .
In order to secure the air guide hoses securely on their con‐
♦
nection fittings, the screw threads must be sprayed with rust
solvent before installing if the screw clamps have been used
beforehand.
Tightening torque for
1 -
Hose clamp -a- = 13 mm wide: 5.5 Nm
2 -
Hose clamp -b- = 9 mm wide: 3 Nm
2.2
Removing and installing charge air cool‐
er
Special tools and workshop equipment required
♦ Screw plug set for engine , e.g. -VAS 6122-
Removing
– Remove coolant radiator
– Loosen hose clamps -1 and 2- and remove air guide hose.
– Close open lines and connections with clean plugs.
272
Rep. gr.21 - Turbocharging/supercharging
⇒ page 213
.