Headlamp Cleaning System; Removing And Installing Headlight Cleaning System Pump V11; Removing And Installing The Lift Cylinder For Spray Nozzles Of Headlight - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
2

Headlamp cleaning system

⇒ "2.1 Removing and installing headlight cleaning system pump
V11 ", page 66
⇒ "2.2 Removing and installing the lift cylinder for spray nozzles
of headlight", page 66
⇒ "2.3 Bleed the headlamp cleaning system", page 67
Summary of components – Components of the headlight washing
system ⇒ Electronic Catalogue of Original Parts .
2.1 Removing and installing headlight
cleaning system pump - V11-
Removing and installing the pump is described in
⇒ "1.1 Removing and installing the washer pump and washer fluid
reservoir", page 62 .
After installing the pump bleed the headlamp cleaning system
⇒ "2.3 Bleed the headlamp cleaning system", page 67
2.2 Removing and installing the lift cylinder
for spray nozzles of headlight
– Remove front bumper ⇒ Body Work; Rep. gr. 63 .
– Press out the spray nozzles with the cover from the bumper
from the inside so that the cover can be grabbed.
– Remove the cover a little, then grab the spray nozzles and pull
out as far as the stop.
– Unclip the cover -1- from the bearing -arrows-.
– Press off the catches -arrows A- using a small screwdriver and
push the lift cylinder -1- out of the bumper -arrow B-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Push the lift cylinder into the brackets in the bumper until it
clicks audibly into place.
– Hoses with angled pieces must click audibly into the connec‐
tions on the lift cylinders for spray nozzles.
– Install bumper.
– After completing the assembly work bleed the headlamp
cleaning system
⇒ "2.3 Bleed the headlamp cleaning system", page 67
66
Rep. gr.92 - Windscreen wash/wipe system
.
.