Table of Contents
Advertisement
Chapter 8
Setting ISDN Primary Rate Annex Values
in the United States,
Australian lines.
displays as selected if the Annex you chose is operating
Other
outside the United States. This setting indicates that the switch
type is set to
to check these values.
The
box allows you to configure the FDL standard. It describes
FDL Type
the facilities data link use. This allows the telephone company to read the
statistics maintained by an Annex and to perform diagnostic tests. There
are four choices:
none
att
ansi
Other
The
box allows adjustment of the cable loss measurement between
Buildout
the last T1 signal regenerator and your location. This measurement is
supplied by the telephone company at installation. You need to adjust your
buildout based on this measurement.There are four choices:
odb
7.5db
15db
20.5db
Using Push Buttons
This window uses
detailed information about push buttons, see .
Setting the Switch Type
Setting the Type
To set a switch type
1
Select a single ISDN Primary Rate Annex in the main window.
2
Display the
8-12
for European lines, and
ETS
or
. You can use CLI admin commands
ETS
ETS-AUS
,
Apply
Restore
window.
T1/PRI Line
CSMIM/Micro-CS Management Application Guide
,
, and
Help
for
ETS-AUS
buttons. For
Close
Advertisement
Table of Contents
