Cabletron Systems CSMIM-T1 Administrator's Manual page 395

multiplexed packet is sent. Entering
Manager's default value).
Type Annex
Values 0 through 255
Default 20
Lists Annex Only, TMux
tmux_enable
controls whether an Annex uses TMux to multiplex small TCP or UDP
packets into a single IP packet. The host must support TMux. If you choose
and the host does not support TMux, the Annex will not support
enabled
multiplexing.
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, TMux
tmux_max_host
specifies the maximum number of host addresses allowed in the TMux
address table. If the number of host addresses exceeds the number you
enter here, the Annex discards the oldest entry.
Type Annex
Values 10 through 255
Default 64
Lists Annex Only, TMux
tmux_max_mpx
specifies the largest user packet that can be placed in a TMux packet. The
Annex does not multiplex larger packets, but passes them directly to the
IP layer.
Type Annex
Values 5 through 65535
Default 700
Lists Annex Only, TMux
CSMIM/Micro-CS Management Application Guide
sets this parameter to 20 (Annex
0
19-95