Table of Contents
Advertisement
Chapter 4
Using the Main Window
You can save any list using the
list using the
Open Annex List
using
and
Add
lists appear later in this chapter.
Creating an Annex List
Creating a List
When you create an Annex list, Annex Manager verifies the name you enter
and displays it, with its hardware type, in the
Annex list:
1
Enter a name or an IP address in the
You can enter an Annex name or its IP address. If you add an
Annex to this list using one identifier (e.g., a name) and repeat
the process using the other identifier (e.g. the IP address) for
the same Annex, a message informs you that the Annex is
already included in the list.
If you enter a device with which Annex Manager cannot
communicate via SNMP,
the Annex type. If you enter a device name that responds to
SNMP but is not an Annex, or if you enter the name of an
unknown device, a warning message informs you that the
4-6
W
ARNING
Figure 4-5. Main Window with Annex List
Save Annex List
command. In addition, you can change lists
. Instructions for saving, opening, and changing
Remove
CSMIM/Micro-CS Management Application Guide
command or recreate a saved
Annex List
Annex
NOT REACHABLE
box. To create an
field.
displays in place of
Advertisement
Table of Contents
