Cabletron Systems CSMIM-T1 Administrator's Manual page 353

load_dump_sequence
specifies available network interfaces and the order in which they are used
for a down-line load or an up-line dump. You can list more than one interface
by using commas to separate interface names. You can enter:
to specify a local area network.
net
sl + port number
a port number, you must enter an address in the
slip_load_dump_host
to instruct an Annex to boot its image from the Flash ROMs.
self
Since the Annex cannot dump back to itself, you should include
a secondary interface here by entering
number.
Type Annex
Value net, sl+ port number, self
Default net
Lists Annex Only, Basic Annex
local_address
defines the IP address for the port on the Annex side of the link. This IP
address is used only when
Type Async
Values IP address
Default 0.0.0.0
Lists Async Port, PPP, SLIP
location
defines a port location or description that displays at the CLI
Type Async
Values 0 to 16 characters
Default " " (null string)
Lists Async Port, Basic Async Port
lock_enable
allows any port to use the LOCK DECServer command.
Type Annex
Values enabled or disabled
Default disabled
Lists Annex Only, Security
CSMIM/Micro-CS Management Application Guide
(e.g., ) to specify a SLIP line. If you enter
sl2
parameter.
is set to
mode
or
self, net
, or
slip ppp, autodetect
and
sl
self,sl+port
.
command.
who
19-53