Table of Contents
Advertisement
Show and Set Commands
Annex Manager may prevent you from changing parameter values based
on the value of the
parameter. If
is set to
,
allow_snmp_sets
allow_snmp_sets
disabled
you can use the
command to reach the Annex and run the
telnet
superuser
command to set
to
.
admin CLI
allow_snmp_sets
yes
The Annex default value does not allow changes to configuration
parameters through SNMP. Annex Manager and the Annex SNMP agent
use SNMP version 1. The only security check performed by the SNMP
agent is to match the community string in an incoming SNMP packet with
the defined community strings for the Annex. Since the community string
in the SNMP packet is transmitted in the clear, there is a potential security
risk in allowing changes to the configuration through SNMP messages. If
you wish to configure the Annex using Annex Manager, please be aware
of this situation.
Returning to Previous Setup mode Window
Because Setup mode windows display based on your selections in previous
windows, you cannot display a second window and then return to another
window. For example, you must close the
) window in order
General (continued
to return to the
window. In addition, you must close all Setup mode
General
windows to return to the main window.
Saving All Configuration Parameters
To save all parameter values for an Annex, use the
command
Create Script
and select all parameters and all ports on the Annex. This may take some
time for Annexes with a large number of asynchronous ports.
Saving Parameters in Scripts
Some Annex configuration parameters include sensitive information. These
parameters include all the Annex and port password parameters, the option
key that applies only for a specific Annex, and the Annex's IP address.
CSMIM/Micro-CS Management Application Guide
20-3
Advertisement
Table of Contents
